User Manual

UM DS-2CEx6H0T-xxITxF 042618NA 10
Figure 13 3-Axis Adjustment
1). Loosen the No.1 adjusting screw to adjust
the pan position [0° to 360°]. Tighten the
No.1 adjusting screw.
2). Loosen the No.2 adjusting screw to adjust
the tilting position [0° to 180°]. Tighten the
No. 2 adjusting screw.
3). Loosen the No.3 adjusting screw to adjust
the rotation position [0° to 360°]. Tighten
the No.3 adjusting screw.
3.2.2 Ceiling/Wall Mounting with Junction Box
Before you start:
You need to purchase a junction box separately.
Steps:
1. Paste the drill template on the ceiling/wall.
2. Drill screw holes and the cable hole (optional) in
the ceiling/wall according to the holes of the drill
template.
Figure 14 Drill Template
Note:
Drill the cable hole when using ceiling outlet to route
the cable.
3. Take apart the junction box, and align the screw
holes of the bullet camera with those on the
Junction box cover.
4. Fix the camera on the junction box cover with
three supplied screws.
5. Secure the junction box body to the ceiling/wall
with supplied screws.