User Manual

UM D-2CE11H0T-PIRL  2018 Hikvision USA Inc.
• DNR (Digital Noise Reduction)
The DNR function can decrease the noise effect, especially when
capturing moving images in poor light conditions, and delivers more
accurate and sharper images. You can set the DNR value from 1 to
9.
• MIRROR
OFF, H, V, and HV are selectable for mirror.
OFF: The mirror function is disabled.
H: The image flips 180° horizontally.
V: The image flips 180° vertically.
HV: The image flips 180° both horizontally and vertically.
4.4 FUNCTIONS
• WHITE LIGHT
The embedded white light source can work as an visible alarm or lighting.
In the WHITE LIGHT mode, you can set the mode to ALARM, LIGHTING, or
OFF.
When you set the WHITE LIGHT to ALARM, you can set the Parameters in
the TRIGGER MODE and the ALARM MODE to meet your needs.
˗ TRIGGER MODE
> DVR 


Set the TRIGGER MODE to DVR. In this way, the alarm signal is sent
from the DVR and the camera works as the alarm detector in the
process. Besides, the alarm type only supported by the DVR can also
trigger the visible alarm in the camera.
> CAMERA
Set the TRIGGER MODE to CAMERA, the embedded PIR module
sends the alarm signal to the visible alarm in the camera when the
PIR module detects the alarm source.
˗ ALARM
In the ALARM mode, you can set the ALARM MODE to SOLID or
FLASHING.
Figure 14, ALARM MODE
> SOLID
Set the ALARM MODE to SOLID. In this way, the white light source
turns on when the PIR module receives the alarm signal.
In the TIME SETTING you can set the time to 5s, 10s, 15s, 30s, or
60s, which means that the solid mode stays for the set time when
the camera receives one alarm signal.
Note:
The solid mode will stay for another set time when a second alarm
signal is received, and the rest can be done in the same way.
> FLASHING
Set the ALARM MODE to FLASHING. In this way, the white light
source flashes when the PIR module receives the alarm signal.