Operation Manual

User Manual of Network Camera

Manual Alarm/Emergency Alarm

Certain series of camera support manual alarm by the remote control. It can be

manually triggered and linked to the audio warning if any emergency happens. You

can press and hold the manual alarm button on the remote control for 2 seconds to

trigger the audio warning manually.

Notes:

 The manual alarm is enabled and armed by default and not user-configurable.

 The manual alarm triggered record will be started if the manual alarm is

triggered on the defined recording schedule, and will be stopped in 10 seconds

after the manual alarm stops. Please refer to Section 7.2 for details about

configuring recording schedule.

6.6.10 Arming or Disarming the Camera

Purpose:

This section is for camera support the function only. You can follow below steps to

configure all-day arming for the camera with the wireless alarm, PIR alarm, motion

detection, tamper-proof, etc.

Notes:

Emergency alarm is enabled and armed by default and not included in this section.

The arming and disarming function can also be realized by the remote control.

 Arm the camera

Steps:

1. Enter the Remote Control interface:

Configuration> Advanced Configuration> System > Remote Control

2. Select Arm from the Arm/Disarm drop-down list.

3. Set the arming delay.

Note: Arming delay refers to a time delay to arm the camera after you set it to

arming status on this page. You can set the delay as 10 seconds, 30 seconds, 1 minute,

3 minutes or 5 minutes. You can also customize the delay time.

Figure 6-45 Arm the Camera

4. Click to arm the camera.

 Disarm the camera

In the Remote Control interface, select Disarm from the Arm/Disarm drop-down list

and click to disarm the camera.

Notes: