Mobile Network Camera Quick Start Guide
Quick Start Guide © 2019 Hangzhou Hikvision Digital Technology Co., Ltd. All rights reserved. This Manual is the property of Hangzhou Hikvision Digital Technology Co., Ltd. or its affiliates (hereinafter referred to as “Hikvision”), and it cannot be reproduced, changed, translated, or distributed, partially or wholly, by any means, without the prior written permission of Hikvision.
OF CONTRACT, TORT (INCLUDING NEGLIGENCE), PRODUCT LIABILITY, OR OTHERWISE, IN CONNECTION WITH THE USE OF THE PRODUCT, EVEN IF HIKVISION HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES OR LOSS.
one or more of the following measures: —Reorient or relocate the receiving antenna. —Increase the separation between the equipment and receiver. —Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. —Consult the dealer or an experienced radio/TV technician for help FCC conditions This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference. 2.
Safety Instruction These instructions are intended to ensure that the user can use the product correctly to avoid danger or property loss. Laws and Regulations The device should be used in compliance with local laws, electrical safety regulations, and fire prevention regulations. Transportation Keep the device in original or similar packaging while transporting it. Power Supply The input voltage should conform to IEC60950-1 standard: SELV (Safety Extra Low Voltage) and the LPS (Limited Power Source).
If the product does not work properly, please contact your dealer or the nearest service center. We shall not assume any responsibility for problems caused by unauthorized repair or maintenance. A few device components (e.g., electrolytic capacitor) require regular replacement. The average lifespan varies, so periodic checking is recommended. Contact your dealer for details. Cleaning Please use a soft and dry cloth when clean inside and outside surfaces of the product cover. Do not use alkaline detergents.
Set up camera time manually for the first time access if the local time is not synchronized with that of the network. Visit the camera via Web browse/client software and go to time settings interface. Installation Make sure the device is firmly secured to any wall or ceiling mountings. Be sure that there is enough space to install the camera and accessories. Make sure that the device in the package is in good condition and all the assembly parts are included.
Warning Forbidden Correct Incorrect Turn to page A and continue. i. Not necessarily included accessory. ii. Variable accessory amount. iii. Skip this step if not required.
Waterproof Skip this step if not necessary
Installation 1
Installation * 1x T20 T10 1x* 2x* 1x 1x 1x 1x 1x 4x* 2
Installation Interface Introduction—Type 1 Reset Button Memory Card Slot Debug Interface RS-485 Interface Power Interface Alarm Interface Audio Interface Network Interface 3
Installation Interface Introduction—Type 2 Reset Button Memory Card Slot Debug Interface RS-485 Interface Audio Interface Alarm Interface Aviation Plug Molex Interface 4
Installation 1.
Installation 2.1 A Ø5.5mm Ø40mm B Ø5.
Installation B A 2.
Installation 2.
Installation 2.
Installation 2.5 A B 2.6 2.
Installation 2.6 5.
Installation 3.1 5.
Installation 3.2 3.
Installation 3.4 3.5 5.
Installation 4.1 4.
Installation 4.
Operation Activate and Access Network Camera Scan the QR code to get Activate and Access Camera. Note that mobile data charges may apply if Wi-Fi is unavailable.
Operation Reset and Restore Camera Press Reset button for about 10s when the camera is powering on or rebooting to restore the default settings, including the user name, password, IP address, port No., etc. For the position of the reset button, refer to the figure in the interface introduction page.
UD16398B
