DS-2CD6825G0-C-IVS-User-Manul
Table Of Contents
- Chapter 1 System Requirement
- Chapter 2 Network Connection
- Chapter 3 Access to the Network Camera
- Chapter 4 People Counting
- Chapter 5 Live View
- Chapter 6 Network Camera Configuration
- Chapter 7 Network Settings
- Chapter 8 Video/Audio Settings
- Chapter 9 Image Settings
- Chapter 10 Event Settings
- Chapter 11 Storage Settings
- Chapter 12 Playback
- Chapter 13 Picture
- Chapter 14 Application
- Appendix
Dual-Lens People Counting Camera User Manual 
3 
Cautions: Injury or equipment damage may be caused if any of these cautions are 
neglected. 
Warnings  Follow  these  safeguards  to 
prevent serious injury or death. 
Cautions  Follow  these  precautions  to 
prevent  potential  injury  or  material 
damage.  
Warnings: 
  Proper  configuration  of  all  passwords  and  other  security  settings  is  the 
responsibility of the installer and/or end-user. 
  In the  use  of  the  product,  you  must  be in  strict  compliance  with  the  electrical 
safety regulations of the nation and region. Please refer to technical specifications 
for detailed information. 
  Input  voltage  should  meet  both  the  SELV (Safety  Extra  Low  Voltage)  and  the 
Limited  Power  Source  with  12  VDC  according  to  the  IEC60950-1  standard. 
Please refer to technical specifications for detailed information. 
  Do  not  connect  several devices  to one  power adapter  as  adapter  overload  may 
cause over-heating or a fire hazard. 
  Please make sure that the plug is firmly connected to the power socket. When the 
product is mounted on wall or ceiling, the device shall be firmly fixed.   
  If smoke, odor or noise rise from the device, turn off the power at once and unplug 
the power cable, and then please contact the service center. 
Cautions:   
  Make sure the power supply voltage is correct before using the camera. 
  Do not drop the camera or subject it to physical shock. 
  Do not touch sensor modules with fingers. If cleaning is necessary, use clean cloth 
with  a  bit of  ethanol  and wipe it  gently.  If the camera  will not  be used  for  an 










