User Manual
Table Of Contents
- Chapter 1 System Requirement
- Chapter 2 Network Connection
- Chapter 3 Access to the Network Camera
- Chapter 4 Live View
- Chapter 5 Network Camera Configuration
- 5.1 Configuring Local Parameters
- 5.2 Configuring System Settings
- 5.2.1 Viewing Basic Information
- 5.2.2 Time and DST Settings
- 5.2.3 RS-232 Settings
- 5.2.4 RS-485 Settings
- 5.2.5 Upgrade and Maintenance
- 5.2.6 Log Searching
- 5.2.7 System Service Settings
- 5.2.8 Authentication
- 5.2.9 IP Address Filter
- 5.2.10 Security Service
- 5.2.11 User Management
- 5.2.12 Open Source Software License
- 5.3 Configuring Network Settings
- 5.3.1 Configuring TCP/IP Settings
- 5.3.2 Configuring Port Settings
- 5.3.3 Configuring PPPoE Settings
- 5.3.4 Configuring DDNS Settings
- 5.3.5 Configuring NAT (Network Address Translation) Settings
- 5.3.6 Configuring SNMP Settings
- 5.3.7 Configuring FTP Settings
- 5.3.8 Email Settings
- 5.3.9 Configuring HTTPS Settings
- 5.3.10 Configuring QoS Settings
- 5.3.11 Configuring 802.1X Settings
- 5.4 Configuring Video and Audio Settings
- 5.5 Configuring Image Parameters
- 5.6 Configuring Event Settings
- 5.7 Configuring Heat Map
- Chapter 6 Storage Settings
- Chapter 7 Playback
- Chapter 8 Picture
- Chapter 9 Application
- Appendix
User Manual of Network Fisheye Camera
88
If Expert is selected as the configuration mode, different sets of parameters are
adopted for motion detection at day and night.
● Day/Night Switch OFF
Steps:
(1) Draw the detection area as in the normal configuration mode. The
supported area number varies according to different camera models.
(2) Select OFF for Switch Day and Night Settings.
(3) Select the area by clicking the area No..
(4) Slide the cursor to adjust the sensitivity and proportion of object in the
area for the selected area.
Sensitivity: The greater the value is, the easier the alarm will be triggered.
Percentage: When the size of the moving object exceeds the set
percentage of the predefined area, the alarm will be triggered. The smaller
the percentage is, the easier the alarm will be triggered.
(5) Set the arming schedule and linkage method as in the normal
configuration mode.
(6) Click Save to save the settings.
● Day/Night Auto-Switch
Steps:
(1) Draw the detection area as in the normal configuration mode. The
supported area varies according to the different camera models.
(2) Select Auto-Switch for Switch Day and Night Settings.
(3) Select the area by clicking the area No..
(4) Slide the cursor to adjust the sensitivity and proportion of object in the
area for the selected area in the daytime.
(5) Slide the cursor to adjust the sensitivity and proportion of object in the
area for the selected area at night.
(6) Set the arming schedule and linkage method as in the normal
configuration mode..