Quick Start Guide

Network Bullet Camera·Quick Start Guide
17
17
Wall Mounting with a Junction Box 2.2
Steps:
1. Drill the screw hole and cable hole according to the supplied drill
template (shown as Figure 2-1).
2. Align the screw holes of the junction box to the drill template, and
fix the junction box to the wall with screws.
3. Route the cables.
4. Fix the camera to the junction box with screws.
5. Adjust the surveillance angle according to step 3 in Chapter 2.1.
6. Install the water-proof jacket according to step 4 in Chapter 2.1.
Drill Template
Installation with a Junction Box Figure 2-6