Manual

User Manual of Network Camera
83
3. Set the video tampering area. Refer to Task 1 Set the Motion Detection Area in
Section 6.6.1.
4. Click Edit to edit the arming schedule for video tampering. The arming schedule
configuration is the same as the setting of the arming schedule for motion
detection. Refer to Task 2 Set the Arming Schedule for Motion Detection in
Section 6.6.1.
5. Check the checkbox to select the linkage method taken for the video tampering.
Audible warning, notify surveillance center, send email and trigger alarm output
are selectable. Please refer to Task 3 Set the Alarm Actions for Motion Detection
in Section 6.6.1.
6. Click Save to save the settings.
6.6.3 Configuring Alarm Input
Steps:
1. Enter the Alarm Input Settings interface:
Configuration > Advanced Configuration> Basic Event > Alarm Input:
2. Choose the alarm input No. and the Alarm Type. The alarm type can be NO
(Normally Open) and NC (Normally Closed). Edit the name to set a name for the
alarm input (optional).
Figure 6-52 Alarm Input Settings