Manual

Network Dome Camera·Quick Operation Guide
12
12
● Make sure that there is no reflective surface too close to the
camera lens. The IR light from the camera may reflect back into
the lens causing reflection.
● The foam ring around the lens must be seated flush against the
inner surface of the bubble to isolate the lens from the IR LEDS.
Fasten the dome cover to camera body so that the foam ring
and the dome cover are attached seamlessly.
Installation of Type I Dome Camera 2.1
Steps:
1. Drill the screw holes and the cable hole according to the supplied
drill template.
Drill Template Figure 2-1
2. Install the mounting base to the ceiling with the supplied screws.
Drill Tempalte
1
1
2
2
2
2
3
3
3
3
4
4
4
4
Screw Hole 3: for
Mounting Base
Hole A: for cables routed
through the ceiling
Code: 190600839