User Manual

7.1.2 Mulcast Discovery
Check the Enable Mulcast Discovery, and then the online network camera can be automacally
detected by client soware via private mulcast protocol in the LAN.
7.2 SNMP
You can set the SNMP network management protocol to get the alarm event and excepon
messages in network transmission.
Before You Start
Before
seng the SNMP, you should download the SNMP soware and manage to receive the
device informaon via SNMP port.
Steps
1. Go to the sengs page: Conguraon → Network → Advanced Sengs → SNMP .
2. Check Enable SNMPv1, Enable SNMP v2c or Enable SNMPv3.
Note
The SNMP version you select should be the same as that of the SNMP soware.
And you also need to use the dierent version according to the security level required. SNMP v1
is not secure and SNMP v2 requires password for access. And SNMP v3 provides encrypon and
if you use the third version, HTTPS protocol must be enabled.
3. Congure the SNMP sengs.
4. Click Save.
7.3 Set SRTP
The Secure Real-me Transport Protocol (SRTP) is a Real-me Transport Protocol (RTP) internet
protocol, intended to provide encrypon, message authencaon and integrity, and replay aack
protecon
to the RTP data in both unicast and mulcast applicaons.
Steps
1. Go to
Conguraon → Network → Advanced Sengs → SRTP .
2. Select Server Cercate.
3. Select Encrypted Algorithm.
4. Click Save.
Note
• Only certain device models support this
funcon.
• If the funcon is abnormal, check if the selected cercate is abnormal in cercate
management.
Network Camera User Manual
54