User Manual

Before You Start
Make sure the external alarm device is connected. See Quick Start Guide for cable connecon.
Steps
1. Go to
Conguraon → Event → Basic Event → Alarm Input .
2. Check Enable Alarm Input Handling.
3. Select Alarm Input NO. and Alarm Type from the dropdown list. Edit the Alarm Name.
4. Refer to Set Arming Schedule for
seng scheduled me. Refer to Linkage Method Sengs for
seng linkage method.
5. Click Copy to... to copy the sengs to other alarm input channels.
6. Click Save.
6.1.6 Set Video Quality Diagnosis
When the video quality of the device is abnormal and the alarm linkage is set, the alarm will be
triggered automacally.
Steps
1. Go to Conguraon → Event → Basic Event → Video Quality Diagnosis .
2. Select Diagnosis Type.
3. Set the corresponding parameters.
Alarm
Detecon Interval
The me interval to detect the excepon.
Sensivity
The higher the value is, the more easily the excepon will be detected, and the higher
possibility of
misinformaon would be.
Alarm Delay Times
The device uploads the alarm when the alarm reaches the set number of mes.
4. Check Enable, and the selected diagnosis type will be detected.
5. Set arming schedule. See Set Arming Schedule .
6. Set linkage method. See Linkage Method
Sengs .
7. Click Save.
Note
The funcon is only supported by certain models. The actual display varies with models.
6.1.7 Set Vibraon Detecon
It is used to detect whether the device is vibrang. The device reports an alarm and triggers linkage
acons if the funcon is enabled.
Network Camera User Manual
41