Quick Start Guide

Network Bullet Camera·Quick Start Guide
21
21
Steps:
1. Paste the drill template to the desired mounting place. Drill the
screw hole and the cable hole according to the supplied drill
template (shown as Figure 2-3).
2. Align the screw holes of the junction box to the drill template, and
fix the junction box to the wall with the screws.
3. Hang the camera with the safety rope of the junction box.
4. Route the cables.
5. Fix the camera to the junction box with the screws.
6. Adjust the surveillance angle according to step 3 in Section 2.2.
7. Install the waterproof jacket according to Section 2.4.
Drill Template
Safety Rope
Junction Box
Figure 2-8 Installation with a Junction Box