Quick Start Guide

Network Bullet Camera·Quick Start Guide
28
28
Steps:
Feed the plugless network cable ⑦ through the lock nut ⑥, 1.
waterproof the rubber gasket ⑤ (rubber gasket inset ridge
must face waterproof endcap), and the waterproof endcap ④
in order.
Crimp an RJ-45 network plug ③onto the end of the cable, 2.
taking care to insert the twisted pairs of wires in correct order.
Place the O-type gasket ② onto the end of the camera’s 3.
network interface socket ①.
Insert the network plug ③ into the camera’s network interface 4.
socket ①.
Insert the waterproof rubber gasket ⑤ into the waterproof 5.
endcap ④, and secure lock nut ⑥ with the waterproof
endcap ④.
Align the snap on the waterproof endcap ④ with the notch on 6.
the camera’s network interface socket ①, and then secure the
waterproof endcap ④ to the camera’s network interface
socket ① to finish installation.