User Manual

Table Of Contents
User Manual of Network Fisheye Camera
98
(7) Click Save to save the settings.
Scheduled Image Settings: Scheduled-Switch
Steps:
(1) Draw the detection area as in the normal configuration mode. The
supported area number varies according to different camera models.
(2) Select Scheduled-Switch for Scheduled Image Settings.
(3) Select the start time and end time for the switching timing.
(4) Select the area by clicking the area No..
(5) Slide the cursor to adjust the sensitivity and proportion of object in the
area for the selected area in the daytime.
(6) Slide the cursor to adjust the sensitivity and proportion of object in the
area for the selected area at night.
(7) Set the arming schedule and linkage method as in the normal
configuration mode.
(8) Click Save to save the settings.
6.6.2 Configuring Video Tampering Alarm
Purpose:
You can configure the camera to trigger the alarm when the lens is covered and take
alarm response action.
Steps:
1. Enter the Video Tampering Settings interface:
Configuration > Event > Basic Event > Video Tampering
2. Check the checkbox of Enable to enable video tampering detection function.