User Manual
Table Of Contents
- Chapter 1 System Requirement
- Chapter 2 Network Connection
- Chapter 3 Access to the Network Camera
- Chapter 4 Wi-Fi Settings
- Chapter 5 Live View
- Chapter 6 Network Camera Configuration
- 6.1 Configuring Local Parameters
- 6.2 Configuring System Settings
- 6.3 Configuring Network Settings
- 6.3.1 Configuring TCP/IP Settings
- 6.3.2 Configuring Port Settings
- 6.3.3 Configuring PPPoE Settings
- 6.3.4 Configuring DDNS Settings
- 6.3.5 Configuring NAT (Network Address Translation) Settings
- 6.3.6 Configuring SNMP Settings
- 6.3.7 Configuring FTP Settings
- 6.3.8 Email Settings
- 6.3.9 Configuring HTTPS Settings
- 6.3.10 Configuring QoS Settings
- 6.3.11 Configuring 802.1X Settings
- 6.3.12 Configuring Platform Access
- 6.4 Configuring Video and Audio Settings
- 6.5 Configuring Image Parameters
- 6.6 Configuring Event Settings
- Chapter 7 Storage Settings
- Chapter 8 Playback
- Chapter 9 Picture
- Appendix
User Manual of Network Fisheye Camera
95
Figure 6-48 Linkage Method Settings
Send Email: Send an email with alarm information to a user or users when
an event occurs.
Note: To send the Email when an event occurs, please refer to Section 6.3.8
to complete Email setup in advance.
Notify Surveillance Center: Send an exception or alarm signal to remote
management software when an event occurs.
Upload to FTP/Memory Card/NAS: Capture the image when an alarm is
triggered and upload the picture to a FTP server.
Notes:
• Set the FTP address and the remote FTP server first. Refer to Section
6.3.7 Configuring FTP Settings for detailed information.
• Go to Configuration > Storage > Schedule Settings > Capture >