User Manual
Table Of Contents
- Chapter 1 System Requirement
- Chapter 2 Network Connection
- Chapter 3 Access to the Network Camera
- Chapter 4 Wi-Fi Settings
- Chapter 5 Live View
- Chapter 6 Network Camera Configuration
- 6.1 Configuring Local Parameters
- 6.2 Configuring System Settings
- 6.3 Configuring Network Settings
- 6.3.1 Configuring TCP/IP Settings
- 6.3.2 Configuring Port Settings
- 6.3.3 Configuring PPPoE Settings
- 6.3.4 Configuring DDNS Settings
- 6.3.5 Configuring NAT (Network Address Translation) Settings
- 6.3.6 Configuring SNMP Settings
- 6.3.7 Configuring FTP Settings
- 6.3.8 Email Settings
- 6.3.9 Configuring HTTPS Settings
- 6.3.10 Configuring QoS Settings
- 6.3.11 Configuring 802.1X Settings
- 6.3.12 Configuring Platform Access
- 6.4 Configuring Video and Audio Settings
- 6.5 Configuring Image Parameters
- 6.6 Configuring Event Settings
- Chapter 7 Storage Settings
- Chapter 8 Playback
- Chapter 9 Picture
- Appendix
User Manual of Network Fisheye Camera
84
3) Check the Enable checkbox to enable ROI function for the chosen region.
4) Select the ROI level.
5) Enter a region name for the chosen region.
6) Click Save the save the settings of ROI settings for chosen fixed region.
7) Repeat steps 1) to 6) to setup other fixed regions if supported.
4. Click Save to save the settings.
Note: ROI level means the image quality enhancing level. The larger the value is, the
better the image quality would be.
Display Info.on Stream 6.4.4
Steps:
1. Enter the Display Info.on Stream Settings interface:
Configuration > Video/Audio > Display Info.on Stream
Figure 6-41 Display Info.on Stream Settings
2. Check the checkbox of Enable Dual-VCA, and the information of the objects (e.g.,
human, vehicle, etc.) will be marked in the video stream. And then you can set
rules on the connected rear-end device to detect the events including line crossing,
intrusion, etc.
6.5 Configuring Image Parameters
6.5.1 Configuring Display Settings
Purpose:
You can set the image quality of the camera, including brightness, contrast, saturation,