User Manual

User Manual of Network Fisheye Camera
59
2. For the cameras support Wi-Fi, there are two NIC tabs selectable. One for LAN
and other one for WLAN. Click the tab to configure the parameters of the selected
NIC.
3. Click the Lan tab to configure the basic network settings, including the NIC Type,
IPv4 or IPv6 Address, IPv4 or IPv6 Subnet Mask, IPv4 or IPv6 Default Gateway,
IPv6 Mode, MTU and Multicast Address. Click the Wlan tab to configure the
basic network settings, including IPv4 Address, IPv4 Subnet Mask and IPv4
Default Gateway.
4. (Optional) Check the checkbox of Enable Multicast Discovery, and then the
online network camera can be automatically detected by client software via
private multicast protocol in the LAN.
5. Configure the DNS server. Input the preferred DNS server, and alternate DNS
server.
6. Click Save to save the settings.
Notes:
 The valid value range of MTU is 1280 to 1500.
 The Multicast sends a stream to the multicast group address and allows multiple
clients to acquire the stream at the same time by requesting a copy from the
multicast group address. Before utilizing this function, you have to enable the
Multicast function of your router.
 A reboot is required for the settings to take effect.
Configuring Port Settings 6.3.2
Purpose:
You can set the port No. of the camera, e.g. HTTP port, RTSP port, HTTPS port and
Server Port.
Steps:
1. Enter the Port Settings interface:
Configuration > Network > Basic Settings > Port