User Manual

Figure 2-10 Set Rule
6.
Oponal: You can set the parameters of mulple areas by repeang the above steps.
7.
For the arming schedule sengs, refer to Set Arming Schedule . For the linkage method sengs,
refer to Linkage Method Sengs .
8.
Click Save.
Set Region
Exing Detecon
It is used to detect objects exing from a predened virtual region. If it occurs, the device can take
linkage acons.
Before You Start
●
Go to VCA → VCA Resource , and select Smart Event.
●
For the device supporng HEOP, go to VCA → APP to import and enable Smart Event.
Steps
1.
Go to VCA → Smart Event → Region
Exing Detecon
2.
Check Enable.
3.
Select a Region. For the detecon region sengs, refer to Draw Area .
4.
Set the minimum size and the maximum size for the target to improve
detecon accuracy. Only
targets whose size are between the maximum size and the minimum size trigger the detecon.
For the detail sengs, refer to Set Size Filter .
5.
Set the detecon target, sensivity and the target validity.
Sensivity
Network Camera User Manual
57