Quick Start Guide

QSG DS-2CD23xxxx-xx Turret 051420NA 29
Figure 42, Waterproof Accessory Installation
2.4 Special Instructions for Attaching Camera to a CB140PT Conduit Base
Some cameras (e.g., DS-2CD23x5G1, DS-2CD23x7G1, DS-2TD1217-2/3/6/V1, DS-2CD23x6G2, DS-
2CD23x6G1, DS-2CD23x7G1, DS-2CD23x6G2, and others) require the following steps to install a
CB140PT conduit base accessory.
1. Twist to remove the trim ring from the camera mounting base.
2. Loosen the pressure clamp locking screw on the mounting base.
3. Slide the pressure clamp away from the mounting base.
4. Detach the mounting base from the camera.
5. Position the mounting base on the CB140PT conduit base.
6. Align the four screw holes on the mounting base to the four inner screw hole posts on the
CB140PT.
NOTE: Do not use the three outer screw holes on the CB140PT rim; you must use the four
inner screw hole posts.
7. Attach the mounting base to the CB140PT with four screws.
8. Restore the assembly:
1) Re-position the pressure clamp.
2) Re-tighten the pressure clamp lock screw.
3) Place the camera body on the mounting base.
4) Re-attach and secure the trim ring.