User Manual

Network Camera User Manual
41
• Face Detection and Heat Map are mutually exclusive. When SMART Event +
Heat Map is enabled, Face Detection interface will not be displayed.
• The function may not be supported by some camera models.
6.3 Maintenance
6.3.1 Upgrade & Maintenance
Purpose:
The upgrade & maintenance interface allows you to process the operations, including
reboot, partly restore, restore to default, export/import the configuration files, and
upgrade the device.
Enter the Maintenance interface: Configuration > System > Maintenance >
Upgrade & Maintenance.
 Reboot: Restart the device.
 Restore: Reset all the parameters, except the IP parameters and user information,
to the default settings.
 Default: Restore all the parameters to the factory default.
Note: After restoring the default settings, the IP address is also restored to the default
IP address, please be careful for this action.
 Export/Import Config. File: Configuration file is used for the batch
configuration of the camera, which can simplify the configuration steps when
there are a lot of cameras needing configuring.
Steps:
1. Click Device Parameters to export the current configuration file, and save it
to certain place.
2. Click Browse to select the saved configuration file and then click Import to
start importing configuration file.
Note: You need to reboot the camera after importing configuration file.
 Upgrade: Upgrade the device to a certain version.