User Manual

Network Camera User Manual
96
Figure 10-7 Video Tampering Alarm
2. Check Enable Video Tampering checkbox to enable the video tampering
detection.
3. Set the video tampering area. Refer to Task 1: Set the Motion Detection Area in
Section 10.1.1.
4. Click Edit to edit the arming schedule for video tampering. The arming schedule
configuration is the same as the setting of the arming schedule for motion
detection. Refer to Task 2: Set the Arming Schedule for Motion Detection in
Section 10.1.1.
5. Check the checkbox to select the linkage method taken for the video tampering.
Audible warning, notify surveillance center, send email and trigger alarm output
are selectable. Please refer to Task 3: Set the Linkage Method for Motion
Detection in Section 10.1.1.