DS-2CDx1xxG0-xxx Network Dome Camera Quick Start Guide
Introduction © 2020 Hangzhou Hikvision Digital Technology Co., Ltd. All rights reserved. This Manual is the property of Hangzhou Hikvision Digital Technology Co., Ltd. or its affiliates (hereinafter referred to as “Hikvision”), and it cannot be reproduced, changed, translated, or distributed, partially or wholly, by any means, without the prior written permission of Hikvision.
Introduction Regulatory Information FCC Information Please take attention that changes or modification not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. FCC Compliance: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Introduction Safety Instruction These instructions are intended to ensure that the user can use the product correctly to avoid danger or property loss. Laws and Regulations The device should be used in compliance with local laws, electrical safety regulations, and fire prevention regulations. Transportation Keep the device in original or similar packaging while transporting it.
Introduction may burn out. Do not expose the device to high electromagnetic radiation or dusty environments. For an indoor-only device, place it in a dry and well-ventilated environment. Do not aim the lens at the sun or any other bright light. Make sure the running environment meets the requirement of the device. The operating temperature shall be -30° to 60° C (-22° to 140° F) or -40° to 60° C (-40° to 140° F), and the operating humidity shall be 95% or less (non-condensing).
Introduction Symbols and Marks Notice Warning Forbidden Correct Incorrect Turn to page A and continue. Not necessarily included accessory. Variable accessory amount. Skip this step if not required.
Introduction Package Contents QSG DS-2CDx1xxG0-xxx 052620NA 7
Introduction Interface Introduction—Type 1 QSG DS-2CDx1xxG0-xxx 052620NA 8
Introduction Interface Introduction—Type 2 QSG DS-2CDx1xxG0-xxx 052620NA 9
Installation Installation 1.1 T20 1.
Installation 2.
Installation A.1 A.
Installation A.3 A.
Installation B.1 B.
Installation B.
Installation 2.
Installation 2.3 2.
Installation QSG DS-2CDx1xxG0-xxx 052620NA 18
Installation 2.
Installation 2.
Installation 3.
Installation 3.
Installation 3.3 3.
Installation 3.
Installation 4.
Installation 4.
Terminal Block Wiring Camera Terminal Block Wiring RS-485 QSG DS-2CDx1xxG0-xxx 052620NA 27
Terminal Block Wiring CVBS QSG DS-2CDx1xxG0-xxx 052620NA 28
Terminal Block Wiring Alarm Output with Power from Camera QSG DS-2CDx1xxG0-xxx 052620NA 29
Terminal Block Wiring Alarm Output with External Power QSG DS-2CDx1xxG0-xxx 052620NA 30
Terminal Block Wiring Alarm Input QSG DS-2CDx1xxG0-xxx 052620NA 31
Terminal Block Wiring 12 VDC Output QSG DS-2CDx1xxG0-xxx 052620NA 32
Activation and Operation Activate and Access Network Camera Scan the QR code to get Activate and Access Camera. NOTE: Mobile data charges may apply if Wi-Fi is unavailable. Operation Reset and Restore Camera Press the Reset button for approximately 10s when the camera is powering on or rebooting to restore the default settings, including the user name, password, IP address, port no., etc. For the position of the reset button, refer to the figure in the interface introduction page.
QSG DS-2CDx1xxG0-xxx 052620NA 34
