User Manual

User Manual of Network Camera
49
to Step 3 Set the Alarm Actions for Motion Detection in Section 5.6.1.
5. You can also choose the PTZ linking for the alarm input if your camera is installed
with a pan/tilt unit. Check the relative checkbox and select the No. to enable
Preset Calling, Patrol Calling or Pattern Calling.
6. You can copy your settings to other alarm inputs.
7. Click to save the settings.
Figure 5-33 Linkage Method
5.6.4 Configuring Alarm Output
Steps:
1. Enter the Alarm Output Settings interface:
Configuration>Advanced Configuration> Events > Alarm Output
2. Select one alarm output channel in the Alarm Output drop-down list. You can
also set a name for the alarm output (optional).
3. The Delay time can be set to 5sec, 10sec, 30sec, 1min, 2min, 5min, 10min or
Manual. The delay time refers to the time duration that the alarm output remains in
effect after alarm occurs.
4. Click to enter the Edit Schedule Time interface. The time schedule
configuration is the same as the settings of the arming schedule for motion detection
Refer to Step 2 Set the Arming Schedule for Motion Detection in Section 5.6.1.
5. You can copy the settings to other alarm outputs.
6. Click to save the settings.