User Manual

User Manual of E Series Analog Speed Dome
© Hikvision
36
Steps:
(1) Move the cursor to EDIT ZONE and click IRIS+ button to enter the edit mode.
(2) You can see SET LEFT LIMIT on the screen. Click the direction buttons to set the left limit.
(3) Follow the prompts on the screen to set the right limit.
(4) Click IRIS+ button to save the settings and exit.
4. Set the zone status and scan status.
ZONE STATUS: The zone status just indicates the current status of the zone.
SCAN STATUS: You can set the scan status to ON/OFF to enable/disable the scanning in the
zone.
ZONE STATUS is not editable. After you edited the zone, it will switch to ON automatically;
if you delete the zone, the ZONE STATUS will switch to OFF.
5. Clear the zone settings.
Move the cursor to CLEAR ZONE, click IRIS+ to clear all the settings of the current zone, and click
IRIS+ again to confirm the settings and exit.
3.5 Others
3.5.1 Restoring Default Dome Settings
Purpose:
You can reset all dome settings to factory default parameters as shown in the table below.
Dome settings are mainly of PTZ parameters and alarm parameters, and also include some
system settings, e.g. dome address.
Enter default dome settings menu:
MAIN MENUS > RESTORE SETTINGS
Click IRIS+ to restore the dome settings to the default value shown as the following table, or click
IRIS- to exit.
3.5.2 Restoring Default Camera Settings
Enter MAIN MENU > RESTORE CAMERA
Click IRIS+ to restore the camera settings to the default value; or click IRIS- to exit.
Camera settings include the image parameters, lens settings and display settings.