User Manual

Table Of Contents

User Manual of E Series Analog Speed Dome

IRIS+ button again to edit.

The tilt range for configuring the privacy masks is from 0° to 70°.

4. Enable or disable the privacy mask function.

Move the cursor to BLANK STATUS. Click IRIS+ button to enter the editing mode and click the up

and down direction buttons to set it ON or OFF.

If no privacy mask has been configured, you cannot set the status as ON.

5. Delete the privacy mask.

You can enter the DELETE MASK menu to delete the all the configured privacy masks.

3.3.3 Configuring Output Standard

Purpose:

The video output standard, including resolution and frame rate, can be changed according to the

actual requirement.

Steps:

1. Move the cursor to enter the Vide Settings submenu:

MAIN MENUS > DOME SETTINGS > VIDEO SETTINGS

2. Move the cursor to VIDEO STD and click IRIS+ to enter the editing mode.

3. Click the up and down direction buttons to select a desired video standard.

4. Click IRIS+ again to confirm and exit the editing mode.

3.3.4 Configuring IR Parameters

The IR parameter settings are supported by IR speed domes only.

Purpose:

You can configure the IR parameters including the IR sensitivity, n/m LED current, reference height,

reference zoom, and LED control, fan control, switch delay, heat control, and IR correction, etc.

Enter the LED parameter submenu:

MAIN MENU > DOME SETTINGS >IR SETTINGS