Spec Sheet

Hikvision USA Inc., 18639 Railroad Street, City of Industry, CA 91748, USA • Hikvision Canada, 4848 rue Levy, St-Laurent, Quebec, Canada, H4R 2P1
Tel: [phone] • Toll Free in USA: [phone] • E-Mail: [e-mail] • www.hikvision.com
© 2018−2020 Hikvision USA Inc. • All Rights Reserved • Specifications subject to change without notice. 030620NA 
Dimensions
Special Installation Instructions for Select Cameras
Some cameras require the following steps to install a CB140PT.
1.
Twist to
remove trim ring from camera mounting
base.
2. Loosen the pressure clamp locking screw on the
mounting base.
3. Slide pressure clamp away from mounting base.
4. Detach mounting base from camera.
5. Position mounting base on the CB140PT.
6. Align four screw holes on the mounting base to
the four inner screw hole posts on the CB140PT.
7. Attach mounting base to the CB140PT with four
screws.
8. Restore the assembly:
1) Re-position the pressure clamp.
2) Re-tighten the pressure clamp lock screw.
3) Place camera body on mounting base.
4) Re-attach and secure the trim ring.
Do not use the three outer screw holes
on the CB140PT rim; you must use the
four inner screw hole posts.
Figure 1, Attaching CB140PT to a
Select Camera Model (Typical)