User's Manual
Table Of Contents
- 1 Introduction
- 2 Installation
- 2.1 Install TF Card and SIM Card
- 2.2 Install Dashboard Camera
- 1. Clean the mounting surface with a mixture of isopropyl and water.
- 2. Remove the stand from the device.
- 3. Peal the paster off the stand.
- 4. Paste the stand to the mounting surface with stand notch vertically downward.
- 5. Push the dashboard camera to the stand along the notch direction, until the camera stuck to the notch.
- 6. Adjust the lens to the target angle.
- 7. Remove the camera from the stand. Tighten the set screw of the lens. Attach the camera to the stand again. Installation finished.
- 2.3 Wiring and Start Device
- 1. (Optional) Connect TVI camera to the dashboard camera’s TVI interface according to needs.
- 2. Connect the dashboard camera’s power cable to the vehicle’s battery:
- a. Connect ACC with vehicle’s ACC;
- b. Connect VCC with vehicle battery’s positive pole；
- c. Connect GND with vehicle battery’s negative pole.
- 3. The dashboard camera starts automatically once the vehicle started. Check the recording indicator.
- If recording indicator is bright and steady, the camera is started normally.
- 3 Trouble Shooting
3
2 Installation
Before you start:
Please make sure that the device in the package is in
good condition and all the assembly parts are
included.
Make sure that all the related equipment is power-off
during the installation.
Check the specification of the products for the
installation environment.
Check whether the power supply is matched with your
power output to avoid damage.
Be sure that there is enough space to install the
camera and accessories.
Make sure the part, which is used to install the
camera, is strong enough to withstand four times the
weight of the camera and the mounting.
If the product does not function properly, please
contact your dealer or the nearest service center. Do
not disassemble the camera for repair or maintenance
by yourself.
Do not pull and drag the camera cables hard.
2.1 Install TF Card and SIM Card
You can install TF card and SIM card according to needs.
TF card will be overwritten when it’s full. The former
recording will be covered automatically. Please backup
recording when accident occurred.
SIM card is used to connect 3G/4G network. The
installation of SIM card and TF card is same.
Steps:
1. Remove the screw, open the card cover.
Remove the screw.
Open Card Cover
2. Push the TF card (self-provided) into the slot until
you hear a click.
3. Cover back the card cover, and tighten the screw.