Quick Start Guide
Table Of Contents
- 1 Overview
- 2 Installation
- 2.1 Installing the Memory Card
- 2.2 Installing DE1Axxx(I) Series PTZ Camera
- 2.3 Installing DE2Axxx(I) Series PTZ Camera
- 2.4 Installing DE2xxx(I) Series Mini PTZ Camera
- 2.5 Installing DE3xxx Series PTZ Camera
- 2.6 Installing DY3xxx Series PTZ Bullet Camera
- 2.7 Installing DE4AxxxI Series PTZ Camera
- 2.8 Installing DE3AxxxI Series PTZ Camera
- 2.9 Installation of Network Cable Water-proof Jacket
- 2.10 Installation of Water-proof Tape
- 2.11 Protective Measures for Outdoor Installation
- 3 Activate and Access Network Camera
Network PTZ CameraยทQuick Start Guide
48
Water-proof treatment is required for cable connectors. Refer to
section 2.9 and 2.10 for details.
6. Put cables in the back box, then close the decorative cover as
shown in Figure 2-69.
Back box
Figure 2-69 Connect the cables
2.9 Installation of Network Cable Water-proof Jacket
Purpose:
If the camera is installed outdoor, you can assemble the water-proof
accessory for the network cable to prevent the equipment from
water.