Quick Start Guide

Network PTZ Camera·Quick Start Guide
16
2.2.2 Wall Mounting
Notes:
 For cement wall, you need to use the expansion screw to fix the
bracket. The mounting hole of the expansion pipe on the wall
should align with the mounting hole on the bracket.
 For wooden wall, you can just use the self-tapping screw to fix
the bracket.
 Make sure that the wall is strong enough to withstand more
than eight times the weight of the PTZ camera and its
accessories.
Steps:
1. Remove the installation plate, and install it on the wall mounting
bracket (not supplied) with two screws.
Note:
Refer to step 1 in section 2.2.1 Ceiling Mounting to remove the
installation plate.
Figure 2-21 Install the Installation Plate
2. Loosen the fixing screw on the bracket and remove the bracket
base.