Quick Start Guide

Network PTZ Camera·Quick Start Guide
ix
 Do not touch senor modules with fingers. If cleaning is necessary,
use clean cloth with a bit of ethanol and wipe it gently. If the
camera will not be used for an extended period, replace the lens
cap to protect the sensor from dirt.
 Do not aim the camera at the sun or extra bright places. Blooming
or smearing may occur otherwise (which is not a malfunction),
and affect the endurance of sensor at the same time.
 The sensor may be burned out by a laser beam, so when any laser
equipment is in using, make sure that the surface of sensor will
not be exposed to the laser beam.
 Do not place the camera in extremely hot, cold, dusty or damp
locations, and do not expose it to high electromagnetic radiation.
 To avoid heat accumulation, good ventilation is required for
operating environment.
 Keep the camera away from liquid while in use.
 While in delivery, the camera shall be packed in its original packing,
or packing of the same texture.
 This equipment is not suitable for use in locations where children
are likely to be present.
 CAUTION: Risk of explosion if the battery is replaced by an
incorrect type. Dispose of used batteries according to the
instructions.
ATTENTION: IL Y A RISQUE D'EXPLOSION SI LA BATTERIE EST
REMPLACÉE PAR UNE BATTERIE DE TYPE INCORRECT. METTRE AU
REBUT LES BATTERIES USAGÉES CONFORMÉMENT AUX
INSTRUCTIONS.