User manual

User Manual of E Series IR Network Speed Dome

2. Click to select the local upgrade file and then click

to start remote upgrade.

Note: The upgrading process will take 1 to 10 minutes. Please don't disconnect

power of the speed dome during the process. The speed dome reboots automatically

after upgrading.

Figure 10-13 Remote Upgrade

10.7 RS-232 Settings

Purpose:

The RS-232 port can be used in two ways:

 Parameters Configuration: Connect a computer to the camera through the serial

port. Device parameters can be configured by using software such as

HyperTerminal. The serial port parameters must be the same as the serial port

parameters of the camera.

 Transparent Channel: Connect a serial device directly to the camera. The serial

device will be controlled remotely by the computer through the network.

Steps:

1. Enter RS-232 Port Setting interface:

Configuration> Advanced Configuration> System > RS232

Figure 10-14 RS-232 Settings

Note: If you want to connect the camera by the RS-232 port, the parameters of the

RS-232 should be exactly the same with the parameters you configured here.

2. Click to save the settings.