User manual

User Manual of E Series IR Network Speed Dome

Figure 6-46 Email Settings

2. Configure the following settings:

Sender: The name of the email sender.

Sender’s Address: The email address of the sender.

SMTP Server: The SMTP Server IP address or host name (e.g.,

smtp.263xmail.com).

SMTP Port: The SMTP port. The default TCP/IP port for SMTP is 25.

Enable SSL: Check the checkbox to enable SSL if it is required by the SMTP

server.

Attached Image: Check the checkbox of Attached Image if you want to send

emails with attached alarm images.

Interval: The interval refers to the time between two actions of sending attached

pictures.

Authentication (optional): If your email server requires authentication, check

this checkbox to use authentication to log in to this server and enter the login

user name and password.

Receiver: Select the receiver to which the email is sent. Up to 2 receivers can be

configured.

Receiver: The name of the user to be notified.

Receiver’s Address: The email address of user to be notified.

3. Click to save the settings.

6.6.7 Configuring Snapshot Settings

Purpose:

You can configure the scheduled snapshot and event-triggered snapshot. You can

upload the captured pictures to a FTP server.

Basic Settings

Steps:

1. Enter the Snapshot Settings interface:

Configuration > Advanced Configuration > Events > Snapshot

2. Check the Enable Timing Snapshot checkbox to enable continuous snapshot.

Check the Enable Event-triggered Snapshot checkbox to check event-triggered

snapshot.

3. Select the quality of the snapshot.

4. Set the time interval between two snapshots.

5. Click to save the settings.

Uploading to FTP

Note: Please make sure that the FTP server is online.