User manual

E-series High-definition Camera·User Manual
5
5
 This installation should be made by a qualified service person and should
conform to all local codes.
 Please install blackouts equipment into the power supply circuit for
convenient supply interruption.
 Please make sure that the ceiling can support more than 50(N) Newton
gravities if the camera is fixed to the ceiling.
Cautions
 Make sure the power supply voltage is correct before using the camera.
 Do not drop the camera or subject it to physical shock.
 Do not touch sensor modules with fingers. If cleaning is necessary, use a
clean cloth with a bit of ethanol and wipe it gently. If the camera will not be
used for an extended period of time, put on the lens cap to protect the
sensor from dirt.
 Do not aim the camera at the sun or extra bright places. A blooming or
smear may occur otherwise (which is not a malfunction however), and
affecting the endurance of sensor at the same time.
 The sensor may be burned out by a laser beam, so when any laser
equipment is being used, make sure that the surface of the sensor will not
be exposed to the laser beam.
 Do not place the camera in extremely hot or cold temperatures (the
operating temperature should be between -40°C ~ 60°C), dusty or damp
locations, and do not expose it to high electromagnetic radiation.
 To avoid heat accumulation, good ventilation is required for a proper
operating environment.
 Do not let water and any liquid flow into the camera.