User manual

E-series High-definition Camera·User Manual

Steps:

1. Rotate to remove the mounting base cover. Loosen the screw on the

mounting base and remove the enclosure and dome from the camera.

Figure 2-31 Remove the Enclosure

2. Drill the holes on the ceiling with the supplied drilling template.

3. Route the cables inside the ceiling or on the surface. If you want to route the

cables inside the ceiling, drill the cable hole in the ceiling for wiring; pull all

cables through the hole and terminate all wires (if not already terminated).

4. Connect the video cable and power cable. Align the holes on the ceiling with

the ones on the mounting base and tighten the screws to secure the

mounting base in the ceiling. Reinstall the dome and enclosure. Fasten the

screw slightly but not tightly.