Installation manual

Installation Manual of Network Camera

1. Disassemble the camera. Refer to section 2.1.

2. View the camera image using the monitor.

3. Loosen the zoom lever and move the lever between T(Tele) and W(Wide) to obtain the

appropriate angle of view.

4. Tighten the zoom lever.

5. Loosen the focus lever and move the screw between F(Far) and N(Near) to obtain the

optimum focus.

6. Tighten the focus lever.

7. Assemble the camera. Refer to section 2.1.

Figure 4-34 Zoom and Focus Adjustment

Chapter 5 Cube Camera Installation

Lever