Installation manual

Installation Manual of Network Camera
45
Figure 3-69 The Drill Template
4. If you want to route the cables inside the ceiling, drill a cable hole in the ceiling according to the
drill template. Skip this step, if you want to route the cables on the surface of the ceiling. Refer to
Conduit Installation on the Side for side cable routing.
5. Attach the camera to the ceiling by aligning the holes of the back box with the holes on the
ceiling.
6. Secure the camera with the supplied screws as shown in the below figure.
Figure 3-70 Secure the Camera
7. Route the cables through the cable hole.
8. Connect the video output connector to the monitor. Connect the power connector to the power
supply.
9. Adjust the image and focus. Please refer to the section 2.3 for more detailed information.
10. Install the inner black liner back to the camera.
Drill Template
Screw Hole
Cable Hole
Back Box
Screws