Installation manual

Installation Manual of Network Camera
43
Table 1-3 Overview
No.
Description
1
Lower Dome
2
Black Liner
3
Reset Button
4
AUX Video Output Interface
5
Serial Port
6
Power interface
7
Ethernet interface
8
Mounting Base
9
Lens
Notes:
 To reset the default parameters to the camera, you need to press and hold the reset button and
power on the camera. After the power on the camera, you must still press and hold the reset
button for about 10 seconds.
 The DS-2CD2712F-IS and DS-2CD2732F-IS models support audio and alarm functions. The
interfaces are shown as follows.
Figure 3-67 Audio and Alarm Interface
3.6.8 Installation
Before mounting, please make sure that the device in the package is in good condition and all the
assembly parts are included.
Notes:
 Please make sure that the device in the package is in good condition and all the assembly parts
are included.
Audio and Alarm Interfaces