Installation manual

Installation Manual of Network Camera
26
Figure 3-35 Adjust Image
6. Reinstall the dome liner and lower dome to finish the installation.
Outdoor mounting:
You can use DS-1242ZJ or DS-1243ZJ for outdoor mounting.
DS-1242ZJ DS-1243ZJ
Steps:
1. Remove the front panel and secure the bracket to the wall or ceiling.
2. Loosen the set screws with the hex key (supplied) to remove the lower dome; remove the dome
liner.
Figure 3-36 Remove the Lower Dome
3. Rotate the toggle to remove it from the toggle bolt; insert the bolt into the toggle bolt hole on
the dome module and use the screw driver to rotate the bolt slightly but not tightly; Reinstall
the toggle and push the dome module to the mounting hole on the bracket with toggle bolts
aligned with the screw holes on the bracket.