Network Camera Installation Manual (5.0.8) UD.
31 Installation Manual of Network Camera 64xx Series Camera Installation 6.
2 Installation Manual of Network Camera Table 1-8 Table 1 1 Description of the Camera No. 1 2 3 4 5 6 7 8 9 Description No.
Installation Manual of Network Camera 33 For cement surface mounting, you need to use the expansion screw to fix the camera. For wooden surface mounting, you can just use the self-tapping screw to fix the camera. 2. Hang the hook which is on upper-side of the main unit onto the rail, press a little harder on the lower part of the main unit, and then the elastic clasp will be automatically buckled.
Installation Manual of Network Camera 34 Concealed Mounting Please make sure that the mounting surface is suitable for adhesive pasting. Steps: 1. Drill on the mounting surface. As shown in Figure 6-6. Figure 6-6 Drill on the Surface Make sure the drilling hole is big enough for the camera lens. 2. Remove a side of the adhesive tape on the bracket. Paste the bracket on the mounting surface with aligning with the drilling hole. As shown in Figure 6-7. Figure 6-7 Paste the Bracket 3.
Installation Manual of Network Camera 35 Figure 6-8 Insert the Block-shaped Sensor Unit Exposed Mounting Steps: 5. Fix the Block-shaped sensor unit on the mounting surface with screws. As shown in Figure 2-7. Figure 6-9 Fix the Block-shaped Sensor Unit For cement surface mounting, you need to use the expansion screw to fix the camera. For wooden surface mounting, you can just use the self-tapping screw to fix the camera. 6. Shield the sensor unit with the decorative cover. As shown in Figure 2-8.
Installation Manual of Network Camera 36 Figure 6-10 Hood the Cover 6.2.3 Installation of Cylindrical Sensor Unit This series of camera only support concealed mounting. Please make sure that the mounting surface is suitable for adhesive pasting. Steps: 1. Drill on the mounting surface. As shown in Figure 6-11. Figure 6-11 Drill on the Surface Make sure that the drilling hole is big enough for the camera lens. 2. Remove a side of the adhesive tape on the bracket.
Installation Manual of Network Camera Figure 6-12 Paste the Bracket 3. Install the cylindrical sensor into the mounting hole in the round rail bracket. 4. Turn the locking sleeve to fix the sensor. As shown in Figure 6-13.
Installation Manual of Network Camera 38
