Instruction manual

Table Of Contents

Network Dome Camera·Quick Operation Guide

● Make sure that there is no reflective surface too close to the

camera lens. The IR light from the camera may reflect back into

the lens causing reflection.

● The foam ring around the lens must be seated flush against the

inner surface of the bubble to isolate the lens from the IR LEDS.

Fasten the dome cover to camera body so that the foam ring

and the dome cover are attached seamlessly.

Steps:

1. Drill the screw holes and the cable hole according to the supplied

drill template.

Drill Template Figure 2-1

(Optional)Routing the cable from the side outlet instead of the

cable hole drilled on the ceiling is supported. Use a plier to

remove the part shown in the figure below, and you can route the

cables from the side outlet.

BOTTOM

Hole