User manual

User Manual of IR Speed Dome
© Hikvision
24
LABLE [PRESET 1 ]
INS
ZOOM+DELETE CONTENTS
FOCUS+CHANGE CONTENTS
FOCUS-CHANGE MARKER
ROCKER CHOOSE CONTENTS
OPEN: SURE CLOSE: BACK
Figure 3-15 Edit the Preset Label(1)
Steps:
(1) Move the cursor to EDIT LABLE and click IRIS+ to enter the edit mode.
(2) Click FOCUS+ in the PTZ control panel to switch between the character lists, including capital
alphabet, lowercase alphabet, symbols and numbers; click the up/down and left/right
direction buttons to move the cursor to choose a specific character to input.
(3) Click FOCUS- to position the cursor on the label where the character needs to be modified.
Click ZOOM IN to delete it.
(4) Click IRIS+ to select the character from the letter/number/symbol list to the label.
(5) Click FOCUS+ to exit the character lists and click IRIS+ again to confirm and exit the
submenu.
LABEL [PRESET 1 ]
INS
LOWCASE[a b c d e f g h I j]
ZOOM+DELETE CONTENTS
FOCUS+CHANGE CONTENTS
FOCUS-CHANGE MARKER
ROCKER CHOOSE CONTENTS
OPEN: SURE CLOSE: BACK
Figure 3-16 Edit the Preset Label(2)
4. Set the preset position.
Move the cursor to PRESET PTZ and click IRIS+ to edit the preset position. Use the direction
buttons to move the speed dome to find the desired scene/position, and then press IRIS+ to
confirm the settings and return to the previous menu, or press IRIS- to cancel.
Note: The preset position settings will be restricted by the limit stops if they are defined.
TASK 2: Clear the preset settings.
Move the cursor to CLEAR PRESET and click IRIS+ to clear the settings of the current preset.
TASK 3: Call the presets.
You can select the preset number from the drop-down preset list in the control panel of the DVR