User manual

User Manual of IR Speed Dome

Note: The new limit stops will overwrite the existed ones by default.

5. You can clear the defined limit stops. Click IRIS+ to enter CLEAR STOPS and click IRIS+ again to

clear the stops.

 Elevation Set

This function is for enabling or disabling the elevation angle in the tilt direction. The elevation angle

is -5º.

3.4.2 Configuring Presets

Purpose:

A preset is a predefined image position. For the defined preset, you can simply click the calling

button to view the desired image position.

TASK 1: Set a preset.

Steps:

1. Move the cursor to enter preset configuration submenu:

MAIN MENUS > DOME SETTINGS > PRESETS

PRESETS

PRESET NUM 1

[UNDEFINED]

PRESET PTZ

CLEAR PRESET

BACK EXIT

Figure 3-14 Preset Configuration Menu

2. Choose the preset number:

Move the cursor to PRESET NUM and click IRIS+ to enter. Click the up and down buttons to

choose the preset number which needs to be edited. If the preset has been defined, the preset

label will be listed under the number; if it has not been defined, you will see [UNDEFINED]

under the number.

Notes:

 There are up to 254 presets can be set for the speed dome.

 The system-defined presets will be displayed on this submenu and they are not editable.

3. Edit the label of the preset.