User manual

User Manual of IR Speed Dome

(1) Enter HALL in the Title filed of the software, click OK, and you’ll see the corresponding

codes 0227-0220-0231-0231 listed for it.

Figure 3-11 Get the Codes of a Character

(2) On the SET TITLE menu, call the presets standing for each code in sequence to enter the

codes. E.g. call preset 10 to get 0, and call preset 2 to get 2. The corresponding numbers,

characters and position information will be displayed on the screen when you are calling the

presets.

(3) You can call preset 16 to delete the character at the current position.

Note: You can set up to 15 characters for the dome title.

9. Exit the title setting menu and display the dome title.

You can call preset 12 twice within 5 seconds to exit the title setting menu and display the title

in the lower right corner; or call preset 13 twice within 5 seconds to exit the title setting menu

and display the title in the lower left corner; or call preset 14 twice within 5 seconds to exit the

title setting menu and display the title in the upper left corner; or call preset 15 twice within 5

seconds to exit the title setting menu and display the title in the upper right corner.

Note: After exit the SET TITLE menu, you can call preset 12 twice within 5 seconds to delete the

defined title and remove it from the screen.

 Display the PTZ movements, alarm, system time, etc.

Purpose:

You can enable or disable the on-screen display of PTZ movements, alarms, time, presets, etc., and

configure the display time.

Steps:

1. Enter the display settings menu:

MAIN MENUS > DOME SETTINGS > SYS INFO SETTINGS > DISPLAY SETTINGS

DISPLAY SETTINGS

ZOOM SHOW 2

PT SHOW 2

ALARM SHOW ON

TIME SHOW ON

PRESET SHOW ON

ZONE SHOW ON

BACK EXIT

DISPLAY SETTINGS

ADDRESS SHOW OFF

ERROR RATE SHOW OFF

FAN AND HEAT SHOW OFF

BACK EXIT

Figure 3-12 Display Settings

2. Move the cursor to DISPLAY SETTINGS using the direction buttons and click IRIS+ to enter.