User manual

User Manual of IR Speed Dome
© Hikvision
13
Configure the LED CONTROL to set the LED control mode. The LED control mode can be AUTO,
FAR(far irradiation distance LEDs) ON, M/F(medium and far irradiation distance LEDs) ON,
MID(medium irradiation distance LEDs) ON, M/N(medium and near irradiation distance LEDs)
ON and OFF.
 Fan parameter configuration
You can set the FAN CONTROL as ON or OFF.
 EIS (Electronic Image Stabilization) configuration
You can set the EIS FUNCTION as ON or OFF; and set the EIS LEVEL as 0-3.
Note: The selectable EIS levels vary depending on the camera models.
 Preset direct focus
You can set the preset direct focus function ON/OF on PRESET DFOCUS submenu.
 Protocol settings
You can set the PROTOCOL STATUS SET as ON or OFF, and set the PROTOCOL SET as AUTO
MATCH, PELCP-P, PELCO-D, Private-code, etc.
 RS-485 checksum setting
You can set the 485CHECK SET as ON or AUTO for improving the controlling effect.
 Power Off Memory
You can set the duration of Power Off Memory as 30s, 60s or 180s for power off memory.
3.3 Configuring Image Parameters
3.3.1 Configuring Camera Parameters
Purpose:
You can set the camera parameters including focus, shutter speed, iris, etc.
Enter the camera parameters settings menu:
MAIN MENUS > DOME SETTINGS > CAMERA PARAMETER