User manual

User Manual of Analog Speed Dome
© Hikvision
40
2. Click IRIS+ to enter edit mode.
3. Click the left/right buttons to select the digit of the current password and click up/down or
FOCUS+/- buttons to set the new value.
4. Click the right direction button to move the cursor to INPUT PW AGAIN and input the password
again.
5. Click IRIS+ to save the new settings and exit.
6. Enter the START USING submenu and switch the status to ON and click IRIS+ to save.
PASSWORD
START USING ON
EDIT PASSWORD
BACK EXIT
INPUT PW 1 2 3 4 5 6
INPUT PW AG 1 2 3 4 5 6
DONE: OPEN
QUIT: CLOSE
Figure 3-27 Set the Password
3.7.3 Restoring Default Dome Settings
Purpose:
You can reset all dome settings to factory default parameters as shown in the table below.
Note: Dome settings are mainly of PTZ parameters and some system settings, e.g. dome address.
Enter default dome settings menu:
MAIN MENU > RESTORE DEFAUTLS
Click IRIS+ to restore the dome settings to the default value shown as the following table, or click
IRIS- to exit.
Table 3-3 Default Dome Settings
Parameters
Default Value
Dome address
0
Baud rate
2400bps
120Ω matching
resistance
Off
Soft address
Off
Focus
HAF
Zoom limit
Max Optical Zoom
Zoom speed
High
Slow shutter
Off
IR cut filter
Day
D/N level
Mid
BLC
Off