User manual

User Manual of Analog Speed Dome
© Hikvision
27
automatically reduce or increase the panning and tilting speed according to the zooming amount.
This function enables the speed dome to trace the object at a proper speed when the speed dome
is zooming and the monitored scene is narrowed (zoom in) or enlarged (zoom out).
You can set PROPORTIONAL PAN as ON or OFF to enable/disable the function.
Note: This function is enabled automatically while setting the patterns.
 Park time and actions
Purpose:
This feature allows the speed dome to start a predefined action (park action: scan, preset, pattern,
etc.) automatically after a period of inactivity (park time).
You can set PARK TIME from 5 to 720 seconds and set the park action (PARK ACT) as preset 1-8,
pattern 1-4, patrol 1-8, pan scan, tilt scan, random scan, frame scan, panoramic scan, day mode,
night mode, patrol-d or none.
Note: If no control signal is received after the park time under the following circumstances, no park
actions will be performed: in the process of performing dome actions by calling special presets.
 Image freeze
This feature enables the live view to switch directly from the current scene to another scene that is
defined by a preset, without showing the middle areas between these two scenes. It reduces the
use of bandwidth in a digital network system and it also provides privacy protection for the middle
areas.
You can set IMAGE FREEZE as ON or OFF to enable or disable this function.
Note: The function varies according to the different camera models.
 PTZ speed
Purpose:
You can define the speed of the dome movements.
(1) DOME SPEED: The manual movement speed of the dome can be set from level 1 to 5.
(2) SCAN SPEED: The scan speed defines the scan degree per second of pan scan, tilt scan, frame
scan, random scan and panoramic scan. The scan speed is adjustable from level 1 to level 40 and
the higher the level is, the faster the scan speed is.
(3) PRESET SPEED: The speed of calling a preset can be set from level 1 to 8. The higher level
corresponds to the faster speed to call a preset.
 Limit stops
Purpose:
The limit stops are user-configurable stops which limit the panning and tilting area of the speed
dome. There are left, right, up and down limit stops to define an area.
Steps:
1. Move the cursor to LIMIT STOPS and click FOCUS+ to set it ON to enable this feature. Click IRIS+
to confirm the new settings.
2. Move the cursor to SETTING STOPS and click IRIS+. You will see the message SET LEFT LIMIT on
the screen.
3. Click the direction buttons in the PTZ panel to configure the left limit stop. Click IRIS+ to confirm