User manual

User Manual of E Series 5-inch Speed Dome
© Hikvision Digital Technology Co., Ltd. All Rights Reserved.
35
You can modify the password and enable/disable the password protection to prevent unauthorized
settings of the speed dome. After you set and enable the password, you need to input the password
every time you call preset 95 to enter the menu.
Steps:
1. Move the cursor to enter the password modification submenu:
MAIN MENU > DOME SETTINGS > PASSWORD > EDIT PASSWORD
2. Click IRIS+ to enter edit mode.
3. Click the left/right buttons to select the digit of the current password and click up/down or
FOCUS+/- buttons to set the new value.
4. Click the right direction button to move the cursor to INPUT PW AGAIN and input the password
again.
5. Click IRIS+ to save the new settings and exit.
6. Enter the START USING submenu and switch the status to ON and click IRIS+ to save.
PASSWORD
START USING ON
EDIT PASSWORD
BACK EXIT
INPUT PW 1 2 3 4 5 6
INPUT PW AG 1 2 3 4 5 6
DONE: OPEN
QUIT: CLOSE
Figure 3-23 Set the Password
3.5.3 Restoring Default Dome Settings
Purpose:
You can reset all dome settings to factory default parameters as shown in the table below.
Note: Dome settings are mainly of PTZ parameters and some system settings, e.g. dome address.
Enter default dome settings menu:
MAIN MENU > RESTORE DEFAUTLS
Click IRIS+ to restore the dome settings to the default value shown as the following table, or click
IRIS- to exit.
Table 3-3 Default Dome Settings
Parameters
Default Value
Dome address
0
Baud rate
2400bps
120Ω matching
resistance
Off
Soft address
Off
Focus
HAF