User manual

User Manual of E Series 5-inch Speed Dome

PRESETS

PRESET NUM 1

[UNDEFINED]

PRESET PTZ

CLEAR PRESET

BACK EXIT

Figure 3-13 Preset Configuration Menu

2. Choose the preset number:

Move the cursor to PRESET NUM and click IRIS+ to enter. Click the up and down buttons to

choose the preset number which needs to be edited. If the preset has been defined, the preset

label will be listed under the number; if it has not been defined, you will see the information

UNDEFINED under the number.

Notes:

 There are up to 255 presets can be set for the speed dome.

 The system-defined presets will be displayed on this submenu and they are not editable.

3. Set the preset position.

Move the cursor to PRESET PTZ and click IRIS+ to edit the preset position. Use the direction

buttons to move the speed dome to find the desired scene/position, and then press IRIS+ to

confirm the settings and return to the previous menu, or press IRIS- to cancel.

Note: The preset position settings will be restricted by the limit stops if they are defined.

4. Call the presets.

You can select the preset number from the drop-down preset list in the control panel of the

encoder through a web browser, and click the arrow to call a user-defined or system-defined

preset.

5. Clear the preset settings.

Move the cursor to CLEAR PRESET and click IRIS+ to clear the settings of the current preset.

3.4.3 Configuring Patrols

Purpose:

A patrol is a scanning track specified by a group of user-defined presets. You can call a patrol to scan

the scenes automatically among the user-defined presets in sequence.

Steps:

 Move the cursor to enter patrol configuration submenu:

MAIN MENU > DOME SETTINGS > PATROLS