Ethernet-over-Coax Extender User Manual UD.
User Manual of Ethernet-over-Coax Extender Thank you for purchasing our product. If there is any question or request, please do not hesitate to contact dealer. This manual is applicable to DS-1H05-T, DS-1H05-T/E, DS-1H05-R, DS-1H05-4R, DS-1H05-8R, DS-1H05-16R Ethernet-over-Coax Extender. This manual may contain several technically incorrect places or printing errors, and the content is subject to change without notice. The updates will be added into the new version of this manual.
User Manual of Ethernet-over-Coax Extender Regulatory information FCC information FCC compliance: This equipment has been tested and found to comply with the limits for a digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.
User Manual of Ethernet-over-Coax Extender 2012/19/EU (WEEE directive): Products marked with this symbol cannot be disposed of as unsorted municipal waste in the European Union. For proper recycling, return this product to your local supplier upon the purchase of equivalent new equipment, or dispose of it at designated collection points. For more information see: www.recyclethis.info.
User Manual of Ethernet-over-Coax Extender Preventive and Cautionary Tips • • In the use of the product, you must be strict compliance with the electrical safety regulations of the nation and region. Please use the power adapter, which is provided by normal company. The standard of the power adapter is 12VDC /1A for DS-1H05-T and DS-1H05-R, 12VDC/2A for DS-1H05-4R, DS-1H05-8R and DS-1H05-T/E, and 12VDC/4A • • for DS-1H05-16R. Please disconnect the power supply before installation or operation.
User Manual of Ethernet-over-Coax Extender • • • • • • The equipment shall be kept from rain and moisture. Exposing the equipment to direct sun light, low ventilation or heat source such as heater or radiator is forbidden (ignorance can cause fire danger). Please use a soft and dry cloth when clean inside and outside surfaces of the equipment, not to use alkaline detergents.
User Manual of Ethernet-over-Coax Extender Table of Contents Chapter 1 Introduction ......................................................................................... 6 1.1 Overview ............................................................................................ 6 1.2 Features .............................................................................................. 6 1.3 Model Description .............................................................................. 7 1.
User Manual of Ethernet-over-Coax Extender Chapter 1 Introduction 1.1 Overview Adopting the newest Security Link Over Coax technology, the DS-1H05 Series Ethernet-over-Coax Extender can be used to transmit the network data and CVBS signal via coaxial cable to the remote device with low signal loss. 1.2 Features Support transmission of Ethernet data and CVBS signal. Up to 500m transmission distance.
User Manual of Ethernet-over-Coax Extender 1.3 Model Description DS-1H05-T: Ethernet-over-Coax transmitter; DS-1H05-T/E: Ethernet-over-Coax transmitter, with PoE power supply; DS-1H05-R: Ethernet-over-Coax receiver; DS-1H05-4R: 4-ch Ethernet-over-Coax receiver; DS-1H05-8R: 8-ch Ethernet-over-Coax receiver; DS-1H05-16R: 16-ch Ethernet-over-Coax receiver.
User Manual of Ethernet-over-Coax Extender 1.
User Manual of Ethernet-over-Coax Extender Chapter 2 Panels and Installation 2.1 Panels of the Transmitter Front Panel: Description of Front Panel: Serial No. LED Indicator Description 1 Video In Connects to the CVBS video input signal. 2 DIP Switch Sets the Ethernet-over-Coax bandwidth. 3 LAN Connects the network signal, e.g., video signal from IP camera, etc.
User Manual of Ethernet-over-Coax Extender Rear Panel: Description of Rear Panel: Serial No. LED Indicator 1 Power 2 Power LED 3 Coax (BNC) Description Connects to 12 VDC power supply. Lights red when the device is powered on. Connects with the receiver for Coax transmission. Note: The DS-1H05-T/E supports PoE capability and can provide max. 12W power supply for the connected camera.
User Manual of Ethernet-over-Coax Extender 2.2 Panels of the 1-channel Receiver Front Panel: Description of Front Panel: Serial No. LED Indicator 1 Video Out 2 DIP Switch 3 LAN Description Sends the CVBS video signal to the terminal device. Sets the Ethernet-over-Coax bandwidth. Sends the network signal to the terminal device.
User Manual of Ethernet-over-Coax Extender Rear Panel: Description of Rear Panel: Serial No. LED Indicator Description 1 Power Connects to 12 VDC power supply. 2 Power LED Lights red when the device is powered on. 3 Coax (BNC) Connects to the Transmitter and receive the modulated network video signal and CVBS analog video signal. 2.
User Manual of Ethernet-over-Coax Extender Front Panel: Figure 2.1 Rear Panel of DS-1H05-16R Note: The DS-1H05-4R/DS-1H05-8R provides 4/8 channel LED indicators on the panel. Description of Front Panel: Serial No. LED Indicator 1 Channel LED Indicator Lights green when the corresponding channel receives the signal normally. 2 ACTIVE LED Indicator Flicks green when there is data transmission. 3 LINK LED Indicator Lights green when the network is connected normally.
User Manual of Ethernet-over-Coax Extender Rear Panel: Figure 2.2 Rear Panel of DS-1H05-16R Note: The DS-1H05-4R/DS-1H05-8R provides 4/8 COAX BNC connectors on the panel. Description of Rear Panel: Serial No. LED Indicator Description 1 GND Grounding. 2 Power 3 4 LAN (10/100/1000Mbps) Coax (BNC) Connects to 12 VDC power supply. Sends the network signal to the terminal device. Connects to the Transmitter and receive the modulated network video signal.
User Manual of Ethernet-over-Coax Extender 2.4 Configuring Coax Transmission Bandwidth You can use the DIP switch settings to configure the downstream bandwidth of the DS-1H05-T or DS-1H05-T/E module and the upstream bandwidth of the DS-1H05-R. Refer to the following table: DIP Switch Transmitter 21 Mbps 25 Mbps 28 Mbps 36 Mbps Receiver 3 Mbps 4 Mbps 9 Mbps 11 Mbps Notes: • The upstream speed of the multi-channel receiver is fixed at 3Mbps by default.
User Manual of Ethernet-over-Coax Extender 2.5 Installation Prior to Installation • Please thoroughly familiarize yourself with the information in this manual prior to installation and operation. • Verify that the package contents are correct by checking the items against the packing list. • Please contact with our company immediately in case of damaged or missing items in the package.
User Manual of Ethernet-over-Coax Extender Appendix: Specifications Model DS-1H05-T DS-1H05-T/E DS-1H05-R Video Input Interface RJ-45/BNC RJ-45/BNC Coaxial BNC Video Output Interface Coaxial BNC Coaxial BNC RJ-45/BNC PoE — Support — ≤ 20 W (when PoE power supply is enabled) Power Consumption ≤5W Power Supply 12 V DC Working Humidity 10 % ~ 90 % Working Temperature -10ºC ~ + 55 ºC Dimensions (W×D×H) 80 × 96 × 27 mm 17 ≤5W
User Manual of Ethernet-over-Coax Extender Model DS-1H05-4R DS-1H05-8R Video Input 4, Coaxial 8, Coaxial Interface BNC BNC 2, RJ-45/BNC 2, RJ-45/BNC 4, RJ-45/BNC Power Consumption ≤ 15 W ≤ 20 W ≤ 30 W Power Supply 12 V DC Working Humidity 10 % ~ 90 % Working -10ºC ~ + 55 ºC Video Output Interface Temperature Dimensions (W×D×H) 440 × 195 × 44.
