DS-1246ZJ Bracket Installation Guide
DS-1246ZJ Bracket Installation Guide 1 Introduction Thank you for purchasing our product. If there are any questions, or requests, please do not hesitate to contact the dealer. This installation guide is applicable to DS-2CD71xx series mini dome camera, such as DS-2CD7153-E, DS-2CD7164-E, and DS-2CD7133-E. This manual may contain several technical incorrect places or printing errors, and the content is subject to change without notice. The updates will be added to the new version of this manual.
DS-1246ZJ Bracket Installation Guide Name Number Securing Plate 1 PM4*8 Screw 4 φ8 Expansion Screw 5 M4*6 Lock Screw 2 Screws: Φ8 Expansion Screw PM4*8 Screw 2 M4*6 Lock Screw
DS-1246ZJ Bracket Installation Guide 2 Bracket Installation Steps Note： Please make sure that the wall is strong enough to withstand three times the weight of the camera and the bracket. 1. Drill the holes on the wall 1). Drill four expansion screw holes and one cable hole on the wall. 2). Feed the power cable and the video cable through the cable hole. 3). Strike the four φ8 expansion screws into the screw hole.
DS-1246ZJ Bracket Installation Guide 2. Install the bracket 1). Remove the nuts and the washers from the expansion screws. 2). Align the mounting base with the expansion holes on the wall. 3). Feed the power/video cable through the bracket. 4). Secure the mounting base to the wall with the removed nuts and washers. Bracket Mounting Base Figure 2-2 Install the Bracket 95 75±0.2 180 158±0.
DS-1246ZJ Bracket Installation Guide 3. Install the back box and the securing plate: 1) Secure the back box to the threaded end of the mounting bracket with the M4*6 lock screws. 2) Insert the securing plate, and secure it with four M4*8 set screws. 3) Feed the power cable and the video cable through the back box and the securing plate.
DS-1246ZJ Bracket Installation Guide 3). Secure the camera to the back box with the two supplied screws. Camera Figure 2-5 Install the Camera 5. Adjust the Lens: 1) Loosen the lock screw beside the lens. 2) View the camera image via the monitor. 3) Adjust the panning position and tilting position and rotate the lens to get the desired surveillance angle. 4).Tighten the lock screws.
DS-1246ZJ Bracket Installation Guide Lock Screw Figure 2-6 Adjust the Lens 6. Install the Camera Lid: 1) Attach the camera lid to the camera 2) Secure the camera lid and the camera with the removed hex screws.
DS-1246ZJ Bracket Installation Guide 8
